Return to 3M Adhesion Promoter sponge

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

DIDN'T NEED IT September 8, 2019 Reviewer: GARRY YORK from CENTRAL POINT, OR United States   MOUNTED LED'S IN AN ALUMINUM CHANNEL Was this review helpful to you?

0 of 0 people found the following review helpful:

August 5, 2019 Reviewer: Raymond Setters from SALT LICK, KY United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Added adhesion December 27, 2017 Reviewer: Chandra Johnson from Jeanerette, LA United States   Good product Was this review helpful to you?

0 of 0 people found the following review helpful:

December 11, 2017 Reviewer: Don Treese from Central City, CO United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Adhesion is good idea June 26, 2017 Reviewer: Dave from Santa Rosa, CA United States   3M makes good stuff... If you're going to tape something onto a bike that vibrates and goes fast, it makes sense to make sure it's well stuck.  This stuff works... just put gloves on prior to handling the pad.  Also a good idea is you just need a buck or two to get you over the free shipping limit. :-) Was this review helpful to you?

0 of 0 people found the following review helpful:

It works March 28, 2017 Reviewer: W. Meyers from Eldersburg , MD United States   Make sure you have your light right the first time. Very hard to remove to adjust after initial installation. Was this review helpful to you?

0 of 0 people found the following review helpful:

Sponge October 12, 2016 Reviewer: Bob k. from Lewes, DE United States   Really helped make sure the adhesive on the lights stuck. Was this review helpful to you?

0 of 0 people found the following review helpful:

Pads June 13, 2016 Reviewer: Thomas Stevenson from Queen creek, AZ United States   I did. It use the product Was this review helpful to you?